ELECSO
ELECSO – Significant Increase in Electrolysis Efficiency Through Electrode Surface Optimization
Contact:
- Prof. Dr.-Ing. Thomas Weißgärber
- Dipl.-Ing. Matthias Gramlich
- Dipl.-Ing. Alexander Schmidt
Electrolyzers that produce hydrogen have traditionally required very clean water to operate stably over the long term. Corrosion and impurities cause the electrodes to degrade, efficiency drops, and in the worst case, the system fails. The ELECSO project therefore focuses on the electrodes and pursues two goals:
1. Higher efficiency: Laser-based surface structuring significantly increases the reactive surface area of the electrodes. At the same time, the resulting gas bubbles (hydrogen and oxygen) detach more easily. This increases the production rate.
2. Greater robustness: Pulsed laser deposition (PLD) allows electrodes to be coated quickly and efficiently with catalytically active material combinations. This also makes it possible to produce alloys and layer structures that are virtually impossible to manufacture using conventional methods. The goal is to develop more corrosion-resistant and efficient alloys and coatings.
The project is a collaborative effort at TU Dresden. Participating departments include the Chairs of Hydrogen and Nuclear Energy (project coordinator), Powder Metallurgy, Chair of Transport Processes at Interfaces, and Chair of Laser-based Manufacturing. ELECSO contributes to energy-efficient, low-carbon hydrogen production and strengthens energy and materials research in Saxony.
Duration: August 1, 2025 – December 31, 2027
Funding Note: The project is funded by the European Regional Development Fund (ERDF) and with tax revenues based on the budget adopted by the Saxon State Parliament under the “ERDF/JTF Research InfraProNet 2021–2027” directive.