Cryolysis of Additively Manufactured Materials
KryoAM – Cryolysis of Additively Manufactured Materials
Contact:
- Prof. Dr.-Ing. Thomas Weißgärber
- Dipl.-Ing. Christoph Höhnel
- Dipl.-Ing. Jakob Scheibler
3D-printed (laser melting) titanium components often exhibit residual stresses, pores, and non-uniform microstructures. Conventional post-processing methods such as heat treatment or hot isostatic pressing are energy-intensive and offer little flexibility. The KryoAM project is therefore investigating cryolysis, a treatment performed at very low temperatures (down to approximately −180 °C). It is intended to relieve residual stresses and homogenize the microstructure without altering the chemical composition. The focus is on the titanium alloys Ti-6Al-4V and Ti-5-5-5-3, which are used in the aerospace, medical technology, and electric mobility sectors, among others. The research examines both 3D-printed components and cryogenically treated powders, including recycled powders.
An interdisciplinary group of early-career researchers is developing reproducible process parameters for this purpose. They analyze the microstructure and mechanical properties and translate the results into simulation and behavioral models. Participants include Chemnitz University of Technology (Lightweight Structures and Plastics Processing, Production Systems and Processes, Electron Microscopy and Microstructural Analysis), TU Dresden (Powder Metallurgy), and Dresden University of Applied Sciences (Materials Engineering). Each of the five Chairs supports one early-career researcher, including those pursuing a Ph.D.
KryoAM contributes to energy- and resource-efficient manufacturing processes and strengthens Saxony as a hub for materials and production.
Project duration: November 1, 2026 – October 31, 2028
Funding Note: The project is funded by the European Social Fund Plus (ESF Plus) under the “Higher Education and Research – STEP” program and approved by the Free State of Saxony through the Sächsische Aufbaubank (SAB).